| Author |
Thread: JVC GR-D271 Recording Questions |
    
Wendy Campbell Unregistered guest |
| Posted on Saturday, February 11, 2006 - 03:32 pm: |
|
I have two questions I was hoping to get answers to:
1) Blank Search: Do I have to perform this operation each time I turn my camcorder power back on? Or if I haven't interrupted the tape via playing it back can I just turn the power on and continue recording?
2) Recording from the middle of a tape: Do I have to engage the Still Playback mode each time I turn my camera back on even if the tape hasn't been interrupted via playing back? I'm concerned about duplicating Time Codes.
Essentially I just want to know if after recording I turn off my camera then begin recoding again, perhaps the next day, do I have to perform the two above mentioned functions or can I just turn it on and begin recording.
Thanks to anyone who can answer these basic, yet confusing, questions.
Wendy |
|
|
|
Gold Member Username: Project6
Post Number: 5565
Registered: Dec-03
|
| Posted on Saturday, February 11, 2006 - 07:41 pm: |
|
1. No, you do not have to perform this if you don't want to. It is a matter of convenience and avoiding excessively long blank portions and to prevent erasure of recorded footage.
2. No.
You can just turn the camera on and begin recording. |
Unregistered guest |
| Posted on Tuesday, February 21, 2006 - 10:29 pm: |
|
Hi,
I have a JVC GR-D33AG camcorder. Recently the problem in that is I am not able to see things while recording.
Once recorded I can only hear the sound, but there is no display.
But before there was no such problems. The display and sound were proper earlier. |
Unregistered guest |
| Posted on Tuesday, February 21, 2006 - 10:29 pm: |
|
Hi,
I have a JVC GR-D33AG camcorder. Recently the problem in that is I am not able to see things while recording.
Once recorded I can only hear the sound, but there is no display.
But before there was no such problems. The display and sound were proper earlier. |
|
