Home > Message Board > Car Audio > Amplifiers > Archive through July 15, 2004 > Need Help for setup
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Need Help for setup
Top of pagePrevious messageNext messageBottom of page Link to this message

Phil Lab
New member
Username: Slayer77

None, None non
Nnoneoneone

Post Number: 1
Registered: Jul-04
Posted on Tuesday, July 13, 2004 - 06:23 pm:    Edit Post
Hi!
I am trying to temporarily run this setup.
1.2 Farad Capacitor
Jensen Jxp 680 (680W Peak Power)Peak 4 Channel

RMS Power Per Channel @ 4 ohm 60x4
Peak Power Bridged @ 4 ohm 340x2
Power Per Channel @ 4 ohm 120x4
RMS Power Bridged @ 4 ohm 170x2

Trying to run: 2* 12" Phoenix Gold XS Series 4 Ohm subs. I wired them in series. They are 250W RMS and 500W peak. I know this amp is not sufficient, I am running it at half gain level. It keeps shutting down. And it comes back up a few seconds after. Why is this happening? Does this damage the subwoofers? Should I wait for my new amp? Do I need to install a fan? This is temporary, I have a 1800W 2 ohm stable 4 chan amp coming soon. It will run subs and speakers.

The Jensen amp is currently bridged and set to LPF. It is plugged on the rear ouput.

Thank you,
Phil
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through July 15, 2004 > Need Help for setup [ « Previous ] [ Next » ]