Home > Message Board > Car Audio > Amplifiers > Archive through July 08, 2004 > How will I wire these?
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: How will I wire these?
Top of pagePrevious messageNext messageBottom of page Link to this message

Bronze Member
Username: Jonez788

Post Number: 41
Registered: Jun-04
Edit Post

How will I wire 2 4 ohm DVC subs into a 2 ohm load? Will it have to be parallel?
Top of pagePrevious messageNext messageBottom of page Link to this message

Silver Member
Username: Davids2004

Houston, TX
USA

Post Number: 240
Registered: Jun-04
Edit Post

cant do it. I put a wiring diagram post in the subwoofer section. Check it out and it will help ya out.
Top of pagePrevious messageNext messageBottom of page Link to this message

Bronze Member
Username: Jonez788

Post Number: 43
Registered: Jun-04
Edit Post

Can I with 2 2 ohm DVC?
Top of pagePrevious messageNext messageBottom of page Link to this message

Bronze Member
Username: Jonez788

Post Number: 44
Registered: Jun-04
Edit Post

Also these are Kicker CVR 12"s
Top of pagePrevious messageNext messageBottom of page Link to this message

Silver Member
Username: Davids2004

Houston, TX
USA

Post Number: 242
Registered: Jun-04
Edit Post

yea with the 2 2ohm dvc you can.

check out this link.

http://jlaudio.com/tutorials/wiring/index.html
Top of pagePrevious messageNext messageBottom of page Link to this message

Silver Member
Username: Davids2004

Houston, TX
USA

Post Number: 243
Registered: Jun-04
Edit Post

yea with the 2 2ohm dvc you can.

check out this link.

http://jlaudio.com/tutorials/wiring/index.html
Top of pagePrevious messageNext messageBottom of page Link to this message

Bronze Member
Username: Jonez788

Post Number: 46
Registered: Jun-04
Edit Post

Okay then I guess I'll get those. This just confused me. Option 1: Both voice coils wired in parallel. This is the ideal load for many subwoofer mono amplifiers. In the case of a dual 4 ohm subwoofer, this would produce a 2 ohm load.


So I'm assuming it's different with a 2 channel amp.
Top of pagePrevious messageNext messageBottom of page Link to this message

Silver Member
Username: Davids2004

Houston, TX
USA

Post Number: 250
Registered: Jun-04
Edit Post

Ok a mono amp is usually stable down to 2 ohms. You cant really bridge a mono amp since its already bridged on the inside.

A 2 channel amp can handle a 2 ohm load stereo mode but a 4 ohm load in bridged mode.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through July 08, 2004 > How will I wire these? [ « Previous ] [ Next » ]