| Author |
Thread: Help |
    
New member Username: Intenz
Barstow,
Ca
U.s.a.
Post Number: 1
Registered: Jun-08
|
| Posted on Friday, June 27, 2008 - 04:11 pm: |
|
how do i install two amps, one to power the door speakers, and the other two power the sub ? |
|
|
|
Silver Member Username: Snowball123
West Allis,
WI
United States
Post Number: 913
Registered: Oct-07
|
| Posted on Friday, June 27, 2008 - 04:30 pm: |
|
run whatever gauge wire to a distribution block and then the distribution block distributes one power wire to sub amp and one power wire to comp. amp, then ground each of the amps. not hard. |
Gold Member Username: Nd4spd18
Northwest PA
Post Number: 7838
Registered: Jul-06
|
| Posted on Monday, June 30, 2008 - 08:23 am: |
|
That or just run 2 power wires |
Bronze Member Username: Vt_ahole
USA
Post Number: 99
Registered: Jun-07
|
| Posted on Tuesday, July 01, 2008 - 08:19 am: |
|
does it make a difference? running two seperate power wires or one to a dist block? |
Gold Member Username: Insearchofbass
Post Number: 9821
Registered: Jun-04
|
| Posted on Thursday, July 03, 2008 - 07:39 pm: |
|
as long as the power wire is good enough for the total amperage running through it you would be better off to run one power wire and a distribution block and a power wire from there to the other amp |
Bronze Member Username: Mario_silva
COATZACOALCOS,
VERACRUZ
MEXICO
Post Number: 28
Registered: Jun-08
|
| Posted on Saturday, July 05, 2008 - 04:40 pm: |
|
make sure ground wires goes to the same point of your chasis. |
|
