| Author |
Thread: Alpine Type R Wiring |
    
Silver Member Username: Audiosaab
Potomac,
MD
Post Number: 135
Registered: Nov-07
|
| Posted on Saturday, May 17, 2008 - 12:44 am: |
|
Hey,
So i, at this very moment, am wiring my subwoofers to my box because i belive i did it incorrectly before...
I am wiring the subwoofers at 1 ohm and they are Alpine Type R 4ohm DVC 12" ers
I wanted to know if anyone has experience with these subwoofers, and if so could you tell me where to place the bannana clips on them, because i can either place them in the holes at the top of each "press" down thing on the 2 + and 2 - areas where u place the wire due to the fact that they fit in there....
or... i could be placing them in the + and - terminal themselves with the + and - wiring from the box but it would be a tad cramped.....
i dont know how else to explain it, but any help would be nice and thanks alot if so 
mike |
|
|
|
Silver Member Username: Shade
Moxee,
Wa
U.S.
Post Number: 658
Registered: Nov-06
|
| Posted on Saturday, May 17, 2008 - 05:54 pm: |
|
banana clips on sub1 do the banana clip positive to positive and negative to negative. and same for the other sub.
i believe that should give u a 1ohm load, also in the manual for the subs it explains how to achieve ohm loads that u desire for upto 4 subs if i remember right. |
|
