| Author |
Thread: Amp to power Vega Stroker 124? |
    
New member Username: Karlmalone
Post Number: 1
Registered: Sep-07
|
| Posted on Tuesday, September 25, 2007 - 02:33 am: |
|
So basically I have this Cerwin Vega Stroker 124 (4 ohm DVC) and I need an amp to power it properly. RMS handling is 2000 watts so I am looking for something around there to get some serious output. My budget is $500-600 so what would be suggested? |
|
|
|
Platinum Member Username: Chaunb3400
Huntsville,
Alabama
U.S.
Post Number: 12876
Registered: Jul-05
|
| Posted on Tuesday, September 25, 2007 - 03:18 am: |
|
so an amp that will do 2000rms @2ohms... Look for a Kicker ZX or KX 2500.1 |
New member Username: Karlmalone
Post Number: 2
Registered: Sep-07
|
| Posted on Tuesday, September 25, 2007 - 06:42 am: |
|
That amp is rated at 2500rms, wouldn't that damage the sub?
Are Alphasonik amps worth considering or are they not so good? |
New member Username: Karlmalone
Post Number: 3
Registered: Sep-07
|
| Posted on Tuesday, September 25, 2007 - 07:04 am: |
|
Also I need something that will accept a 4g wire or larger. I was looking at those Hifonics amps because the numbers look really good but after reading some commentary on here I am looking for something else.
Are MMATS amps still high quality or have they also gone to hell? |
Platinum Member Username: Chaunb3400
Huntsville,
Alabama
U.S.
Post Number: 12879
Registered: Jul-05
|
| Posted on Tuesday, September 25, 2007 - 12:15 pm: |
|
"That amp is rated at 2500rms, wouldn't that damage the sub?"
noooo, u should be fine...just set ur gains,eq's,etc. correctly and u will be fine
also ur gonna need 0ga wire, 4gauge wire is 2 small for that much current...
Hifonics and Alphasonik are both really questionable amps....Personally i wouldnt get either one of them...Ask for MMats they still have decent stuff... |
Gold Member Username: Juliob
Santo Domingo
Dominican Re...
Post Number: 4927
Registered: Dec-05
|
| Posted on Tuesday, September 25, 2007 - 02:01 pm: |
|
that's true |
New member Username: Karlmalone
Post Number: 4
Registered: Sep-07
|
| Posted on Tuesday, September 25, 2007 - 05:39 pm: |
|
i actually have 0 gauge wire but the kicker amps are listed as having smaller terminals, so do i just use an adapter to make it fit into the amp or what? |
|
