| Author |
Thread: Crossfire VR404 |
    
Silver Member Username: Kklagge
San Diego
Post Number: 404
Registered: Dec-04
|
| Posted on Friday, February 16, 2007 - 08:31 pm: |
|
Just bought this amp...the manual says the input sensativity only goes to 3.2v....my HU puts out 4v....am I screwed now or is there a way to make this work....anyone anything about this amp? Could the 3.2v be a typo? Haven't really seen too many amps that stop at such a low voltage.
Thanks |
|
|
|
Gold Member Username: Adddisorder
West palm,
Florida
Post Number: 3244
Registered: Jan-06
|
| Posted on Saturday, February 17, 2007 - 02:37 pm: |
|
it will work fine, just the amp may reach its peak befor the volume on HU is maxed so just listen i run 6.5v pre outs with an amp that only accepts 4v its all in the tuning and levals |
Silver Member Username: Kklagge
San Diego
Post Number: 405
Registered: Dec-04
|
| Posted on Saturday, February 17, 2007 - 04:43 pm: |
|
Okay I will give it a go...just don't want to ruin the new pair of A/D/S comps I just purchased...I guess 3.2v is closer to 4v than your 4v is to 6.5v |
Gold Member Username: Adddisorder
West palm,
Florida
Post Number: 3253
Registered: Jan-06
|
| Posted on Saturday, February 17, 2007 - 06:02 pm: |
|
yeah just back off on the volume when they sound distored if you even get to that point. they will reach their full potential because the amp will be at max befor your volume is at max so keep that in mind and just listen wisely |
|
