Home > Message Board > Car Audio > Amplifiers > Archive through August 06, 2006 > Wiring question
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Wiring question
Top of pagePrevious messageNext messageBottom of page Link to this message

Nate So
Silver Member
Username: Killswitchjd

Post Number: 278
Registered: Apr-06
Posted on Monday, July 31, 2006 - 05:11 pm:    Edit Post
so my amplifier is a mono 1200x1 rms amp, but it has two sets of speaker terminals. In the manual it says that the load is internally paralleled. So how do I go about wiring two dual 4 ohm subs to these seperate terminals to get a 1 ohm load?
Top of pagePrevious messageNext messageBottom of page Link to this message

bassman3
Gold Member
Username: Dustin3

Tigard, OR
U.S.

Post Number: 2850
Registered: Oct-05
Posted on Monday, July 31, 2006 - 05:13 pm:    Edit Post
two dVC sub wire to a 1 or 4 ohm load.

what amp is this? link? and what subs?
Top of pagePrevious messageNext messageBottom of page Link to this message

ty mutlow
Gold Member
Username: Tjmutlow

Post Number: 2653
Registered: Sep-05
Posted on Tuesday, August 01, 2006 - 05:33 am:    Edit Post
on each sub run + to + and - to -(voice coil) then run that way to amp(each terminal)
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through August 06, 2006 > Wiring question [ « Previous ] [ Next » ]