Home > Message Board > Car Audio > EQs and Crossovers > Archive through August 01, 2006 > Hooking up ground and power for eq to...
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Hooking up ground and power for eq to distribution block??
Top of pagePrevious messageNext messageBottom of page Link to this message

Blair
Bronze Member
Username: Blair

Brisbane, Queensland
Australia

Post Number: 25
Registered: May-05
Posted on Wednesday, March 29, 2006 - 01:08 am:    Edit Post
Is it common practice to hook up the power and ground on a active x-over or eq via the same distribution block for you amps or not?

Alternatively, should it be run from a power wire from behind the dash?

Also is it recommended running say a 1amp fuse on the eq power connection??
Top of pagePrevious messageNext messageBottom of page Link to this message

Kicker Kevin
New member
Username: Kevin420

Gilbert, Az
USA

Post Number: 10
Registered: Apr-06
Posted on Wednesday, April 05, 2006 - 12:40 am:    Edit Post
my eq"in dash" has it's own ground, uses same factory power wire as h/u. Active crossover "in trunk" has it's own ground, but shares power off a dist block shared by my 4ch. No noise problems??? hope it helps
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > EQs and Crossovers > Archive through August 01, 2006 > Hooking up ground and power for eq to... [ « Previous ] [ Next » ]