Home > Message Board > Car Audio > Amplifiers > Archive through April 23, 2004 > Advice needed from glasswolf
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Advice needed from glasswolf
Top of pagePrevious messageNext messageBottom of page Link to this message

rick
New member
Username: Capulina6

Post Number: 5
Registered: Apr-04
Posted on Saturday, April 17, 2004 - 03:22 pm:    Edit Post
hey glasswolf i was wondering if you were familiar with Concept amps, if you are would you be able to tell me why my CC-D1200A mono amp has two speaker outputs as if it were a 2/channel amp??? i am stuk on his and dont know how to wire my subs to it as i was expecting only one output
Top of pagePrevious messageNext messageBottom of page Link to this message

GlassWolf
Gold Member
Username: Glasswolf

NorthWest, Michigan
USA

Post Number: 1984
Registered: Dec-03
Posted on Saturday, April 17, 2004 - 05:52 pm:    Edit Post
two sets of terminals for wiring two subs to the amp
it'd be a parallel set of terminals so using both will wire the subs in parallel for you
if you have two 4 ohm subs, wire one to each set of terminals.
simple as that.
the manual should have explained that.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through April 23, 2004 > Advice needed from glasswolf [ « Previous ] [ Next » ]