| Author |
Thread: Setting up for highs amd mids |
    
Bronze Member Username: Chevelle
Lancaster,
Pa
Usa
Post Number: 18
Registered: Feb-05
|
| Posted on Thursday, March 17, 2005 - 12:09 pm: |
|
Question when setting up for highs and mids is it best to bridge the 6 1/2 or run them stereo and when setting the amp for hpf's whats the best setting for it around 80hz or 100hz |
|
|
|
Gold Member Username: Carguy
Post Number: 1997
Registered: Nov-04
|
| Posted on Thursday, March 17, 2005 - 12:29 pm: |
|
When you say bridge, do you mean left and right channels? You always want stereo for components.
For midbass, set it around 100hz if you get too much cone movement, if not, then 80hz. It all depends no the type of music you listen to.
|
Bronze Member Username: Chevelle
Lancaster,
Pa
Usa
Post Number: 19
Registered: Feb-05
|
| Posted on Thursday, March 17, 2005 - 12:42 pm: |
|
ok the reason i ask is i got my subs wired 2ohm and run them stereo i wasn't sure if i should rewire them to make one 4ohm lead to amp and do the same with the 6 1/2's or just leave it the way it is and bridge the 6 1/2 but now i know stereo for mids and highs.So i know now 100hz and if to much cone movement 80hz.The music is mostley bass music i have my subs set at 100hz on lpf does that sound about right for lpf |
Gold Member Username: Carguy
Post Number: 1998
Registered: Nov-04
|
| Posted on Thursday, March 17, 2005 - 01:52 pm: |
|
Your setting for LPF is fine. Most people have it around 80Hz - 100Hz. |
|
