Home > Message Board > Car Audio > Amplifiers > Archive through December 02, 2004 > Dual voice coil help
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Dual voice coil help
Top of pagePrevious messageNext messageBottom of page Link to this message

New member
Username: Rezzie

Post Number: 1
Registered: Dec-04
Edit Post

ok heres the set up, i have an L7 12" sub in a sealed box, made by subzero (www.subzeromfg.com) it has 2 pairs of terminals im assuming 1 per voice coil. i have gone thru a series of amps and subs in the past and have purchased 2 500watt mono amps. these amps are the same model they put out about 350rms, i was planning on reusing these amps as to i dont want to spend money on another amp, would it be possible to hook up 1 amp per coil to the sub? or is there any way i can configure wires to take advantage of the 2 amps to power this 1 sub? the amps are 2 ohm stable and my L7 is 2 ohms per coil, in theory it makes sense to just hook up 1 amp per coil. any help will be appreciated
tia
Top of pagePrevious messageNext messageBottom of page Link to this message

Silver Member
Username: Carguy

Post Number: 576
Registered: Nov-04
Edit Post

Hey Marcus, you can attach one amp per terminal. What you have to be careful of is the signal to both amps. You will need a splitter for the rca cable from HU to connect the same signal to both amps. If you operate the 2 amps in stereo mode, you will fry the voice coils.
Top of pagePrevious messageNext messageBottom of page Link to this message

New member
Username: Rezzie

Post Number: 2
Registered: Dec-04
Edit Post

i need a splitter? i cant have use the in/outputs of the amp? say hu to amp 1 imput, amp 1 output to amp 2 input? if the splitter is the only route thats not a problem, can u vouche any good name brand splitters? thanx
Top of pagePrevious messageNext messageBottom of page Link to this message

Silver Member
Username: Carguy

Post Number: 581
Registered: Nov-04
Edit Post

Hey Marcus, if your amps already have a pass through rca jacks, then use them. It'll do the same job as a splitter cable.
BTW, if you needed to get one, Radio Shack or most audio places sell them for few dollars.

Top of pagePrevious messageNext messageBottom of page Link to this message

New member
Username: Rezzie

Post Number: 3
Registered: Dec-04
Edit Post

ic, sounds good. so as long as im not running into stereo mode this should be fairly save correct?
Top of pagePrevious messageNext messageBottom of page Link to this message

Silver Member
Username: Carguy

Post Number: 586
Registered: Nov-04
Edit Post

Yes, in mono your sub will be ok.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through December 02, 2004 > Dual voice coil help [ « Previous ] [ Next » ]