Home > Message Board > Car Audio > Amplifiers > Archive through November 14, 2004 > Amp and speaker wiring
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Amp and speaker wiring
Top of pagePrevious messageNext messageBottom of page Link to this message

shawn Corp
New member
Username: Hurleyblink187

Post Number: 7
Registered: Nov-04
Posted on Friday, November 12, 2004 - 10:38 am:    Edit Post
umm im about to purchase a Audiobahn AW120T sub, along with a sounstorm 500x2 amp, just a question, when i go to bridge the channels doesnt that give me a 2ohm impendance. or it doesnt matter as long as you have the sub wired at 4 ohm, the Audiobahn AW120T is single 4-0hm voice coil. just wanted to make sure this would work out before i bought this.
Top of pagePrevious messageNext messageBottom of page Link to this message

tim clark
Bronze Member
Username: Thrust

Post Number: 16
Registered: Nov-04
Posted on Friday, November 12, 2004 - 12:28 pm:    Edit Post
technically it is a 2 ohm load to the amp, however if the manufacturer says the amp will work mono (bridged) into a 4 ohm load them you should be fine. And I've never seen a bridged amp that won't push (1) 4 ohm speaker
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through November 14, 2004 > Amp and speaker wiring [ « Previous ] [ Next » ]