Home > Message Board > Car Audio > Amplifiers > Archive through November 04, 2004 > Mono-block amp with 2 outputs???
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Mono-block amp with 2 outputs???
Top of pagePrevious messageNext messageBottom of page Link to this message

iheartbass
Unregistered guest
Posted on Monday, November 01, 2004 - 08:23 pm:    Edit Post
i was kind of confused because my amp is a mono classd amp but its got two speaker outputs. so my question is if i have a dual voice coil sub do i HAVE TO wire each coil to each terminal or can i wire both coils to the same terminal to make it easier to connnect the box since it only has one sub?
Top of pagePrevious messageNext messageBottom of page Link to this message

GlassWolf
Gold Member
Username: Glasswolf

NorthWest, Michigan
USA

Post Number: 5408
Registered: Dec-03
Posted on Monday, November 01, 2004 - 09:33 pm:    Edit Post
you use a short set of wires to jumper the DVC coils together.
wire the sub to one set of amp terminals.
both sets of terminals are in parallel. it just makes wiring two subs easier.. that's all.
it's in the manual.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through November 04, 2004 > Mono-block amp with 2 outputs??? [ « Previous ] [ Next » ]