| Author |
Thread: Amp output |
    
New member Username: Vybz05
Post Number: 1
Registered: Oct-04
|
| Posted on Thursday, October 21, 2004 - 03:42 pm: |
|
I have a problem. I am going to buy a car <a href="http://www.serverlogic3.com/lm/rtl3.asp?si=11&k=audio%20system">audio system</a>. I'm going to get (2) Alpine SWS-1242d subwoofers. 300 watts RMS. They are DVC at 4 ohms each. I have read that if i wire them in parallel, i will end up with a 1 ohm load. Now, for the amplifier, the question is, if i buy an amp that puts out 600 watts RMS at 2 ohms, will it match the subwoofers even though they are at 1 ohm. Basically, can i feed 2ohms to 1ohm and still sound good? |
|
|
|
Silver Member Username: Johnnylemoine
LaPlace,
Louisiana
United States
Post Number: 220
Registered: Aug-04
|
| Posted on Thursday, October 21, 2004 - 04:14 pm: |
|
you would have to get a 1 ohm stable amp as to not fry an amp that is only 2 ohm stable. |
New member Username: Vybz05
Post Number: 2
Registered: Oct-04
|
| Posted on Thursday, October 21, 2004 - 04:34 pm: |
|
like the jbl bp600.1? |
|
