Home > Message Board > Car Audio > Amplifiers > Archive through October 19, 2004 > Jbl amp
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Jbl amp
Top of pagePrevious messageNext messageBottom of page Link to this message

michael F
Unregistered guest
Posted on Sunday, October 17, 2004 - 12:42 am:    Edit Post
I have two rockford fosgate 12" punch HX2 RFD2212 subwoofers 500rms each I was thinkin about getting the jbl bp-1200.1 1Z mono amp do you guys think i will blow them out if i wire them at 2ohms? Also how do i wire them to the amp I know how to wire the subwwofers in parallel but the amp has two speaker channels - + - + do i wire them in bridge or how? And about the rca outputs theres two right channel and two left channel do i have to connect two sets of av jacks? Please help me.
Top of pagePrevious messageNext messageBottom of page Link to this message

GlassWolf
Gold Member
Username: Glasswolf

NorthWest, Michigan
USA

Post Number: 4750
Registered: Dec-03
Posted on Sunday, October 17, 2004 - 01:00 am:    Edit Post
RTFM.

wire one sub to each set of terminals.
they're in parallel. one channel, two pair of inputs to simplify the install.
use Y splitters to give all 4 RCA inputs a signal for best results with a JBL amp.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Car Audio > Amplifiers > Archive through October 19, 2004 > Jbl amp [ « Previous ] [ Next » ]