Home > Message Board > Home Theater > Home Theater Setup & Planning > Archive through September 08, 2004 > Sub Install Question
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Sub Install Question
Top of pagePrevious messageNext messageBottom of page Link to this message

Brad A
New member
Username: The_underboss

Post Number: 1
Registered: Aug-04
Posted on Tuesday, August 10, 2004 - 02:51 am:    Edit Post
Hey all,

I bought a new Sony Home Theater receiver and the output for the sub is a single RCA.

My subwoofer, an older cheaper one, is part of an old "All in One" system I had. How can I make the old sub work with the new single RCA output? The sub right now is controlled by speaker wires only.

Is it possible to cut the end off a single RCA cable and use those two wires inside on the speaker wire side to connect the sub?
Top of pagePrevious messageNext messageBottom of page Link to this message

Berny
Gold Member
Username: Project6

Post Number: 1132
Registered: Dec-03
Posted on Tuesday, August 10, 2004 - 09:56 pm:    Edit Post
no, this single input is designed to accept signals from an LFE or subwoofer source and will accept low level inputs only and not high level speaker signals.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Home Theater > Home Theater Setup & Planning > Archive through September 08, 2004 > Sub Install Question [ « Previous ] [ Next » ]