Home > Message Board > Home Theater > Home Theater Setup & Planning > Archive through November 16, 2003 > SAE Power amp hook-up...
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: SAE Power amp hook-up...
Top of pagePrevious messageNext messageBottom of page Link to this message

Michael Scholfield
Posted on Saturday, September 20, 2003 - 08:00 pm:    Edit Post
Hi, everyone. I have an SAE 2300 Power amp (150/channel). I need help with the hook-up. The back of the unit says both "wide" and "high-pass" for each channel. How do I hook this up - do I use a standard RCA from the amp to the pre-amp or receiver? I tried this in both the "wide" and "high-pass" output, but get no LED indication. Any help would truly be appreciated.

Thanks,

Michael S.
Top of pagePrevious messageNext messageBottom of page Link to this message

Anonymous
Posted on Tuesday, October 07, 2003 - 08:21 pm:    Edit Post
Pre-amp -- yes. Important that you have a Volume control or you get 150 watts - full output.
Either wide or hipass ok. Hipass cuts out very low frequencies and DC. No LED is another story.
Chk.: not plugged in.
fuse on back panel is blown
switch not on (mine doesn't have a switch)
led's do not work (but music ok)
if fuse keeps blowing, major problems but worth spending some money on - it sounds great!
Note: you should have some kind of speakers connected when you try it.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Home Theater > Home Theater Setup & Planning > Archive through November 16, 2003 > SAE Power amp hook-up... [ « Previous ] [ Next » ]