Home > Message Board > Home Theater > Home Theater in a Box > Archive through November 29, 2005 > Yamaha rx-v392 receiver
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Yamaha rx-v392 receiver
Top of pagePrevious messageNext messageBottom of page Link to this message

Jason Villeneuve
New member
Username: Jasonx

Waterloo, Ontario
Canada

Post Number: 1
Registered: Sep-05
Posted on Tuesday, September 06, 2005 - 03:31 pm:    Edit Post
My Yamaha rx-v392 receiver keeps turning off 2 seconds after i turn it on.
I keep checking the connections but they are all fine.
1 of the turning knobs to hold the speaker wire in the back of the receiver is broke and wont turn but that isnt the cause of this because i have held it in place while trying the receiver and still turns off right away.
Anyone have any suggestions on what could be done to fix this?
It cost alot of money and i cant even use it
Thanks alot for any help
Top of pagePrevious messageNext messageBottom of page Link to this message

Hank Diver
New member
Username: Diverhank

Huntington Beach, CA

Post Number: 7
Registered: Sep-05
Posted on Thursday, September 08, 2005 - 07:07 pm:    Edit Post
If I were you I'd be removing wires a set at a time until the unit stays on. Apparently there is a short somewhere in the wiring. I assume that you have been visually checking the connections?

Another possibility (unlikely imho) is that the electrical outlet simply does not have enough current for the unit (if you have tons of things hooked up to it). My bet is a short though.
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Home Theater > Home Theater in a Box > Archive through November 29, 2005 > Yamaha rx-v392 receiver [ « Previous ] [ Next » ]