Home > Message Board > Home Theater > Home Theater Setup & Planning > Archive through January 29, 2005 > Help with banana wire connectors
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Help with banana wire connectors
Top of pagePrevious messageNext messageBottom of page Link to this message

adsfadsfadfasdfadsfsadf
Unregistered guest
Posted on Sunday, January 23, 2005 - 04:03 pm:    Edit Post
I'm wondering if they will work on my speakers. It's hard to explain but the way you plug wire into my speakers is by pushing down on a part which has a spring to push it back up and hold wire in place. There is a black and red one on each speaker. So, will banana connectors be able to fit in the hole which is slightly less than 1/2 centimeter. I'm looking at these:
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=091-1260&scqty=3
Please help and ask if you dont understand. Thanks!
Top of pagePrevious messageNext messageBottom of page Link to this message

Perry
New member
Username: Gojhawks

Post Number: 4
Registered: Dec-04
Posted on Sunday, January 23, 2005 - 05:59 pm:    Edit Post
I am assuming you are talking about speakers with "spring clips" like these: http://akamaipix.crutchfield.com/graphics/infolib/homelib/lSpeakerSpringClip.jpg
If so then I do not believe banana plugs will work. Either use the bare wire or can use a pin connector like this: http://akamaipix.crutchfield.com/graphics/infolib/homelib/lSpeakerPinConnector.j pg
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Home Theater > Home Theater Setup & Planning > Archive through January 29, 2005 > Help with banana wire connectors [ « Previous ] [ Next » ]