| Author |
Thread: Help with HK AVR525 and video connections and other ?? |
    
New member Username: Dougg
Atlanta,
GA
Post Number: 6
Registered: Apr-04
|
| Posted on Saturday, December 11, 2004 - 04:03 pm: |
|
I have a HK AVR525 that is connected as follows:
TV:
S video from HK to S video in on TV
Audio out from TV L/R to Video 2 Audio In on HK
CD:
Coax digital out to Coax digital In on HK
VCR:
Video Out to Video 1 Input on HK
Video In to Video 1 Output on HK
R/L Audio output to Video 1 Audio Input on HK
R/L Audio Input to Video 1 Audio Out on HK
DVD
S Video out to DVD Video In on HK
Digital Optical Out to Optical Dig Audio In on HK
On the analog inputs (TV and VCR) I have them set to Dolby Pro Logic II.
Question: Is this the best setting or would Logic 7 be better (or any of the other choices)
On the digital input of the DVD, I have set to Dolby Digital.
Question: Again, is this the best choice?
When using DVD or VCR, I can hear the sound but not see any picture.
Question: What do I have set up wrong? Do I need to go S video right from the DVD to the TV and bypass the HK? Do I need to run composite cables straight from the VCR to the TV and bypass the HK? If I do both of the above, I will have no direct input from the HK to the TV (TV only has one S Video and one Video in, but no component) and will lose the ability for On Screen directions?
Last question: I have the following speakers
Front: Dahlquist DQM9, 35Hz - 22kHz
Surround: Dahlquist QX6A, 37Hz - 20kHz
Center: Dahlquist QX50C, 55Hz - 20kHz
Sub: Dahlquist PDQ1200, 30Hz - 150Hz
I have my speakers set to Large for the fronts and small everywhere else. I have the crossover set for 80Hz on all speakers. Does this sound right or should I have them set differently?
Thanks very much for any help to this newcomer to home theatre.
Doug
|
|
|
|
New member Username: Dougg
Atlanta,
GA
Post Number: 7
Registered: Apr-04
|
| Posted on Sunday, December 12, 2004 - 08:33 pm: |
|
Help? Anybody??? |
|
