| Author |
Thread: Color Wheel will not ignite ballast once placed in housing. |
    
New member Username: Captchancey
Cape Coral,
Florida
Post Number: 1
Registered: May-09
|
| Posted on Wednesday, May 20, 2009 - 05:08 pm: |
|
My DLP Samsung 67 had a color wheel go out. So I replaced it. Then I replaced the ballast and the lamp. I followed all of Ovadoggva's instructions and bought from the company's he said to. However the colerwheel will only fire up the ballast outside of it's housing. When I place it in the housing it will not fire up the ballast. Please help me with this.
Thank you very much.
Regards,
Capt Ben |
|
|
|
New member Username: Coolpairpl
Post Number: 6
Registered: May-09
|
| Posted on Thursday, May 21, 2009 - 11:20 am: |
|
Ben, I'm trying to test my color wheel out of the housing, is there anything special you had to do to get it to spin? |
New member Username: Captchancey
Cape Coral,
Florida
Post Number: 2
Registered: May-09
|
| Posted on Thursday, May 21, 2009 - 11:31 am: |
|
Joe,
Thank you very much for responding. It really means a lot to me. I have had this TV down for 4 months now because I became frustrated with it. Other than mashing down the little lever without the cover I have not done anything different that I know of. I read under OVA's thread where you can check the color wheel that way. It spins it's little heart out when I test it that way. Thanks for the help.
Regards,
Capt Ben |
New member Username: Coolpairpl
Post Number: 7
Registered: May-09
|
| Posted on Thursday, May 21, 2009 - 12:23 pm: |
|
Ben, could you tell me where you found OVA's thread on testing it this way? |
|
