Home > Message Board > Home Video > Rear Projection TVs > Archive through December 19, 2006 > Mitsubishi WT42311 Bowing problem?? ...
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Mitsubishi WT42311 Bowing problem?? Please help
Top of pagePrevious messageNext messageBottom of page Link to this message

david potter
New member
Username: Dplaser

West palm beach , Florida
Usa

Post Number: 1
Registered: Dec-06
Posted on Thursday, December 14, 2006 - 05:15 pm:    Edit Post
I have seen many of the suggestions for this problem and its apparent that there is an inherient failure with the mitsubishi projection convergence module ICS... My question is on this model (WT 42311) where it appears to have the same internal layout.. Is the convergence board IC location located on the giant heat sink unit seen from the front of the TV ( with the speaker shroud removed and board removed). Or is the ICs on the small board mounted on the larger board in the middle. The convergence board appears to have 2 connectors on the left and 3 connectors on the right.. But its burried in the back and tough to get at. As well as having the HV Anode leads from the CRT's.. Does all this come out. Are those ICs that need to be removed contained side by side on the heat sink..Strapped to the heat sink with heat sink compound.. As well as having many legs on the bottom of it... a bit confused.. PLEASE HELP in west palm beach florida...thanks
Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Home Video > Rear Projection TVs > Archive through December 19, 2006 > Mitsubishi WT42311 Bowing problem?? ... [ « Previous ] [ Next » ]