| Author |
Thread: Micromix MM4 and peavey SP-4 hook up |
    
Bronze Member Username: Northerncomfort
Sudbury,
Ontario
Canada
Post Number: 18
Registered: May-04
|
| Posted on Sunday, December 30, 2007 - 01:36 pm: |
|
was looking for advice.I have a mm4 mixer,has two rear outputs for speakers,rating 4ohm min/total and i have 2 peavey sp-4 cabinets rated 4 ohms.My question is,is there any difference if i hook them up-one speaker per chanel on the amp or hook up one speaker in one channel and run the other speaker off that one.Will there be a different load on the amp??? |
|
|
|
Platinum Member Username: Jan_b_vigne
Dallas,
TX
Post Number: 11909
Registered: May-04
|
| Posted on Sunday, December 30, 2007 - 02:09 pm: |
|
.
Uh, yeah. Running loads in parallel is different than not running loads in parallel. |
|
