Home > Message Board > Home Audio > Amps > Archive through September 11, 2005 > Powering 960wt amp
Main Topics Main Topics   Your Account Your Account Search Search   Help/Instructions Help
Today's Posts Today's Posts | Last 3 Days Bookmark and Share
Author Thread: Powering 960wt amp
Top of pagePrevious messageNext messageBottom of page Link to this message

john mullins
New member
Username: Jekz409

Post Number: 10
Registered: Jul-05
Posted on Tuesday, August 30, 2005 - 03:49 am:    Edit Post
i just purchased a Kenwood KAC-7202 amp (460wtx1@4ohms)(960wt peak in some magical land)and im using a 350 wt 12v-20a PSU, i knew in the first place it wouldnt quite cut it.. and the it turning off when i put it past 20 volume confirmed that... if i went to say radio shack what could i get something other than a PSU that i could just plug into the outlet, wire it to the amp, and it would run.. umm better if not how it would if wired to a car battery. and id rather not buy one of those
Top of pagePrevious messageNext messageBottom of page Link to this message

jimny_boy
Unregistered guest
Posted on Friday, September 02, 2005 - 05:46 pm:    Edit Post
what size fuse(s) has the amp got? that indicates how much current is needed. Then try and buy a supply that matches the current.
Top of pagePrevious messageNext messageBottom of page Link to this message

john mullins
Bronze Member
Username: Jekz409

Post Number: 14
Registered: Jul-05
Posted on Friday, September 09, 2005 - 09:35 pm:    Edit Post
umm i believe the amp has a 40A Fuse.. btw if im using 2 psu's do the ground wires and 12v's go directly to the connectors on the amp or is there a problem with 2 being connected to that?.. and what in my room would you think is grounded?

thanks for any help

Topics | Last Day | Search | Formatting Tips | Terms | Rules | Help | Log out | Bookmark and Share
Home > Message Board > Home Audio > Amps > Archive through September 11, 2005 > Powering 960wt amp [ « Previous ] [ Next » ]